On 2/11/26 2:32 PM, Andrew Randrianasulu wrote:

--------------

8) Build procedure further from here?

Where does the bld_dynamic.sh script fit in?

./configure --with-single-user --disable-static-build --without-thirdparty

(there are some typos in the manual: "confgure" instead of "configure" pdf page 12, 13. 653)

setting CFLAGS?

should not be necessary, but you can try and see if it fails :)

I think --with-single-user is safer, and you can use

bld_appimage.sh

for appimage-ing result of (hopefully successful) compilation.

Note, I did not tried this with dynamic cingg build ... Hopefully
appimagetool will only add loaders and not whole .. hw driver stack.

I think blds/bld_dynamic.sh is maintainer script more than user script

It was not updated to new git protocol (https vs git)

So you probably can skip it and just manually use your
"--without-thirdparty --with-single-user --disable-static-build"
configure line,
and then make and make install

test and appimage it

Or possibly a configure line like this to include link to my system ffmpeg?

"--without-thirdparty --with-single-user --disable-static-build --with-ffmpeg=/usr/bin/ffmpeg" 

_________________________
Cin mailing list -- cin@lists.cinelerra-gg.org
To unsubscribe send an email to cin-leave@lists.cinelerra-gg.org