On Tuesday, May 18, 2021, mat via Cin <cin@lists.cinelerra-gg.org> wrote:
On Tue, 2021-05-18 at 17:59 +0300, Andrew Randrianasulu via Cin wrote:
> fun fact - but directly pasting this log {just 29 kb} to gmail's
> mobile web mail interface resulted in page reload...
>
> so i copypasted it via pre-installed wps office.
>
> most suspecting imo
>
> audio_output_ptr = {0xf66050a0, 0xf66050d0, 0x0 <repeats 30 times>
>
> but may be those just pointers on one for each channel, so 0x0 is
> normal for unused channels
Andrew, if I understood correctly, you are trying to get CinGG to work
on a specific arm64 device? Would such an CinGG also work on say qemu
with fedora34 arm64? Or is is very specific?
well, more like arm8 / (cortex-a53) (all userspace here is 32-bit, not sure if cpu can do 64 bit? )
i think usual glibc-based arm(64) distro should be even easier as compilation environment.. just add your case into guicast/Makefile:
diff --git a/cinelerra-5.1/guicast/Makefile b/cinelerra-5.1/guicast/Mak
efile
index cf189dea..fc086f92 100644
--- a/cinelerra-5.1/guicast/Makefile
+++ b/cinelerra-5.1/guicast/Makefile
@@ -12,6 +12,11 @@ ifeq ($(OBJDIR), amd64) BOOTSTRAPFLAGS := -DBOOTSTRAP="\"objcopy -B i386 -I binary -O elf64-x8
6-64\""
endif
+ifeq ($(OBJDIR), armv8l) +BOOTSTRAPFLAGS := -DBOOTSTRAP="\"objcopy -B arm -I binary -O elf32-littlearm\""
+endif
+
+
for arm64 -O probably will be elf64-littlearm..
and put
CFLAGS += -DNO_BTRACE
CFLAGS += -DNO_CTX
CFLAGS += -DNO_GDB
{ mostly for bcsignals.C }
in global_config after configure but before make (i still not figured out how to put this in
configure.ac depending on arch.. there already exist x86(-64) test for adding or not adding nasm, so i probably can just invert this logic? )
some libs in thirdparty may need their config.guess updated before they recognize relatively new architecture.. i just copied system's (automake?) config.guess into each dir manually when i was building for e2k... but most likely thirdparty/Makefile can be used for automating this..
+libogg.cfg_vars?= autoreconf -ifv -I m4 && automake -caf;
libogg.cfg_params?= --enable-shared=no
i'll attach my e2k patch, only as reference... (some __i386__ ifdefs are correct, but some missing relative to my current set of termux/arm patches....)
good luck! (-dev libs + build itself may take nearly 4gb, at least my termux install weights some more than 4gb already.. but i have some extras like gtk3 installed)
MatN
--
Cin mailing list
Cin@lists.cinelerra-gg.org
https://lists.cinelerra-gg.org/mailman/listinfo/cin