[Cin] Add-timecode-to-output-mov-mxf.patch

[Phyllis Smith]

 Andrea/Andrew:

> The 0030-Add-timecode-to-output-mov-mxf.patch works and introduces
> timecode in both mov and mxf and also in mp4 (instead it doesn't work in
> mkv). Thanks! I propose to put this patch in git.
>

It is a good idea but I tested it and it works and shows up in mediainfo
BUT there is an error message that is a problem and I do not understand.
Maybe Andrew can look at this as shown below where the new lines and error
(codec open failed) is in BOLD as shown on the startup window.

*AFTER 0030*
...
Cinelerra is free software, covered by the GNU General Public License,
and you are welcome to change it and/or distribute copies of it under
certain conditions. There is absolutely no warranty for Cinelerra.
...
*tc: 0.000000*
Render::render_single: Session finished.
** rendered 2713 frames in 7.326 secs, 370.325 fps
*FFMPEG::scan: codec open failed*
*FFMPEG::scan:file=/tmp/junafter.mp4*
audio0 pad 32 0 (32)


BEFORE 0030
...
Cinelerra is free software, covered by the GNU General Public License,
and you are welcome to change it and/or distribute copies of it under
certain conditions. There is absolutely no warranty for Cinelerra.
...
Render::render_single: Session finished.
** rendered 2713 frames in 9.759 secs, 278.000 fps
audio0 pad 32 0 (32)
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.cinelerra-gg.org/pipermail/cin/attachments/20211111/609d969b/attachment.htm>